EDGE SINGLE MAGAZINE CASE - INSTRUCTIONS
belt loop width size adjustment and customization for mod. 1926
STEP 1:
Position holder with FlexiMount facing you, as shown.
STEP 2:
Rotate locking mechanism to release MOLLE bars.
Step 3:
Squeeze MOLLE Bars at the same time as indicated by the arrows and pull up to open.
STEP 4:
With the MOLLE Bars in the open position, use the provided Allen Wrench to remove the center screw highlighted in red.
STEP 5:
Flip your adapter over and use the provided hex wrench to unscrew both screws highlighted in red. Keep screws close.
STEP 6:
Remove the belt width adjuster and adjust to desired belt height. Reinsert the two screws previously removed from belt width adjuster and tighten. Do not overtighten.
STEP 7:
Reassemble by placing the adapter/screw back on (center hole will position the adapter to factory position).
adjustment and customization of inclination
STEP 1:
Position holder with FlexiMount facing you, as shown.
STEP 2:
Rotate locking mechanism to release MOLLE bars.
Step 3:
Squeeze Molle Bars at the same time as indicated by the arrows and pull up to open.
STEP 4:
With the MOLLE Bars in the open position, use the provided Allen Wrench to remove the center screw highlighted in red.
STEP 5:
Once you have chosen your desired CANT angle, reinsert the screw and place back in the middle circle highlighted. Secure tightly with the provided hex wrench.
tighten or loosen retention
STEP 1:
Use provided hex wrench to adjust the two screws highlighted in green to your desired retention level.
